Locally Based in Newport Beach
Epoxy Garage Floors in Newport Beach
Pelora Surfaces is based right here in Newport Beach, and epoxy garage floors are our flagship service. Flake systems run $7 to $10 per square foot, metallics $10 to $16, installed by insured crews and backed by a workmanship warranty in writing. Every floor starts with diamond ground prep, never an acid etch shortcut.
The Flagship Service
Salt air is relentless. So is this floor.
A garage here works harder than most rooms in the house. On Lido Isle and the Balboa Peninsula it holds boat gear, paddleboards, and sandy beach equipment. In Dover Shores and Newport Heights it stages e-bikes and golf carts that roll in wet and salty. Harbor and ocean salt air works on every finished surface it touches, and bare concrete takes the worst of it: dusting, pitting, and stains that never quite rinse out. A sealed, glossy floor stands up to salt, sand, and moisture, and finishes the garage like the rest of the house.
That is why we build every Newport Beach floor the same way: diamond ground prep, never acid etch shortcuts, moisture testing before any coating goes down, and crack and pit repair included. Choose a flake system for a subtle, stone flecked finish or a metallic pour for a floor no neighbor can match. Insured crews do the work, and the workmanship warranty comes in writing.
- Flake systems $7 to $10 per sq ft, metallics $10 to $16
- Diamond ground prep and moisture testing, never acid etch shortcuts
- UV stable topcoat rated for hot tire pickup, no peeling, no yellowing
- Built for salt air and sandy beach gear, from Lido Isle to Eastbluff
- Locally based in Newport Beach, insured crews, warranty in writing
- Crack and pit repair included before any coating goes down
The Proof
Same garage, new floor
Drag the handle. Bare concrete on one side, a finished Pelora Surfaces floor on the other.
Before
After
Pricing covers diamond ground prep, crack and pit repair, moisture testing, and a UV stable topcoat built for coastal sun and salt. We are based here in Newport Beach, so book the free 20 minute on site estimate and get an exact written quote before any work begins.
Every product we use has pet safe and kid safe options, landscaping is pre soaked and protected, and treated areas are rinsed thoroughly before we leave.
Beyond Epoxy Garage Floors
Every Pelora Surfaces service, in Newport Beach
Pressure Washing
Driveways, patios, and walkways across Newport Beach stripped of grime and brought back to bright.
House Soft Washing
The whole exterior washed gently at low pressure, algae killed at the root, windows rinsed spot free.
Concrete Cleaning
Oil, rust, and oxidation lifted with targeted chemistry, plus optional sealing and concrete painting.
Gutter Cleaning
Cleared by hand, flushed, flow tested, and documented with photos.
Epoxy Floors
Flake and metallic garage floors over diamond ground prep, warrantied in writing.
Full Exterior Refresh
House, concrete, and gutters in one visit: one crew, one schedule, one warranty.
Questions
Epoxy Garage Floors in Newport Beach: FAQ
How much does it cost to epoxy a garage floor in Newport Beach?
A standard two car garage of about 450 sq ft runs $2,800 to $4,500 for a flake system and $4,000 to $7,000 for a metallic. That works out to $7 to $10 per square foot for flake and $10 to $16 for metallic. Every job starts with a free on site estimate and an exact written quote before any work begins.
How soon can I park on a new epoxy floor in Newport Beach?
You can typically park in 24 to 48 hours with our polyaspartic grade topcoat systems. Light foot traffic is fine in 12 to 24 hours, and we recommend waiting 3 to 5 days before moving contents back so the coating reaches full chemical cure.
Will an epoxy floor hold up to the salt air in Newport Beach?
Yes, a properly built system is one of the best defenses a Newport Beach garage has against harbor salt air. We pair an epoxy build coat with a high performance UV stable topcoat rated for hot tire pickup, so the floor does not peel or yellow in the sun. Much of Newport Beach sits within about 2 miles of the coast, which is exactly the environment we moisture test and prep for.
What is the difference between flake and metallic epoxy?
Flake runs $7 to $10 per square foot and reads clean and granite-like, hiding sand and dust between sweeps. Metallic runs $10 to $16 per square foot and pours into a glossy, one of a kind surface with real depth. Both systems get identical prep: diamond grinding, moisture testing, and crack and pit repair.
Do you install epoxy garage floors on Lido Isle or the Balboa Peninsula?
Yes, Pelora Surfaces is based in Newport Beach and installs throughout the city, including Lido Isle, the Balboa Peninsula, and Big Canyon. The free on site estimate takes about 20 minutes and comes with an exact written quote before any work begins.
Why do you diamond grind instead of acid etching?
Because diamond grinding gives epoxy a true mechanical bond, and it is included in our $7 to $10 per square foot flake rate. Acid etching is a shortcut that leaves residue and weak adhesion, which is how floors end up peeling, so we never use it. We also moisture test every slab and repair cracks and pits before coating.
Free Estimate
Ready to transform your Newport Beach home?
Free on site estimate, about 20 minutes, exact written quote before any work begins.